Total Drive Care Solutions Logo
TOTAL DRIVE CARE Next-Gen Auto Engineering
← Back to Insights Hub
COOLING SYSTEMS • October 28, 2026 • 9 min read

Preventing Engine Overheating in Tropical Heat: Radiator & Coolant Care

Engine overheating is one of the most common causes of catastrophic engine failure in Sri Lanka. Internal combustion engines generate immense heat during fuel combustion. The engine cooling system must dissipate thousands of thermal calories per minute through the radiator. In stop-and-go tropical traffic, an inefficient cooling system can overheat in under five minutes.

Why You Must Never Use Plain Tap Water as Coolant

Many local drivers make the critical error of topping up radiators with plain tap water or well water. Tap water contains dissolved minerals (calcium and magnesium) and chlorine that cause severe damage:

  • Internal Radiator Clogging: Mineral scale deposits precipitate on hot radiator micro-tubes, choking coolant flow and causing boiling.
  • Galvanic Corrosion: Dissolved minerals turn water into an electrolyte, causing galvanic corrosion between the aluminum cylinder head, steel engine block, and copper heater core.
  • Cavitation Water Pump Wear: Plain water boils at 100°C. Vapor bubbles implode against high-speed water pump impellers, eroding aluminum blades.

Always use a certified 50/50 pre-diluted Ethylene Glycol or Organic Acid Technology (OAT) Coolant. Quality coolant raises the boiling point to 128°C under pressure and contains rust inhibitors.

Critical Cooling System Components to Inspect

Inspect these cooling components during routine servicing:

  • Radiator Pressure Cap: The radiator cap contains a spring-loaded pressure relief valve calibrated to 0.9 bar or 1.1 bar. If the rubber gasket cracks, pressure escapes, lowering the boiling point and causing coolant to boil over into the expansion tank.
  • Engine Thermostat: The thermostat regulates engine temperature by opening at approximately 82°C to 88°C to allow coolant into the radiator. If it fails in the closed position, coolant is trapped in the engine block, causing immediate overheating within miles.
  • Electric Radiator Fans: Modern fans use dual-speed electric motors controlled by the ECU. Test that the cooling fan kicks into high speed when the air conditioning compressor engages.

Emergency Actions if Your Temperature Gauge Climbs

If your engine begins to overheat on the road:

  1. Turn off the air conditioning immediately to remove load from the engine.
  2. Turn the cabin heater to maximum temperature and full blower speed. The heater core acts as a secondary mini-radiator to dissipate heat.
  3. Pull over to a safe location, place the gearbox in Park or Neutral, and leave the engine idling for two minutes. If you see steam billowing from under the hood, shut off the engine immediately.
  4. NEVER attempt to open the radiator cap while the engine is hot. Wait at least 30 minutes for system pressure to drop.

Need Professional Automotive Assistance?

Visit our diagnostic and repair workshop at Athurugiriya or call our rapid assistance line.